Mira vigour User's Guide download pdf (Page 15)

7. Temporarily locate the shower unit.

8. Position the shower unit on the wall

and mark the three xing points.

Note! Installers may wish to obtain

alternative proprietary cavity xings

for dry lined, stud partition or dry

partition wall structures.

9. Use the push-t release tool to push

the grey collars into the manifold to

release the shower unit from the

supply pipes.

Warning! Make sure there are no

buried cables or pipes near the xing

points before drilling.

10. Drill 9.5 mm holes and t the wall

plugs supplied.

11. Cut away and trim the thinned

section at the top or bottom of the

case to allow the electrical supply

cable to run down the rear of case.

Fixing Points

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Mira vigour User's Guide Page 15