Mira Coda User's Guide download pdf (Page 17)

Lubricants

Silicone based lubricants must only be used on the rubber seals.

Caution! Oil based or other lubricant types may cause rapid deterioration of seals.

Cleaning

The chrome plated parts should be cleaned using a mild washing up detergent or

soap solution, rinsed and then wiped dry with a soft cloth.

Warning! Many household cleaners contain abrasive and chemical substances,

and should not be used for cleaning plated or plastic ttings.

Do not use descalents on this product.

Maintaining the Non-Return Valves

Sealing Washer / Filter

Inlet Connector / Non-Return

Valve Housing

Non-Return Valve

The non-return valves are located in the thermostatic bar valve body, and are

accessible through the inlet connectors.

Caution! Make sure that the non-return valves are installed correctly to prevent

crossow or malfunction of the valve.

1. With the water supplies turned off and

the thermostatic bar valve removed,

remove the sealing washer / lter.

2. Unscrew the non-return valve housing

using a 12 mm hexagonal wrench.

Note! The non-return valve housing

has a Left Hand Thread, turn

clockwise to unscrew.

3. Carefully remove the non-return

valve and clean out any debris.

4. On re assembly make sure that the

non-return valve is tted the correct

way round (with the arrow indicating

the ow pointing towards the valve).

Filters

The sealing washers/lters are located in the inlet connector. Clean or renew as

necessary.

1 2 ... 12 13 14 15 16 17 18 19 20

No comments

Mira Coda User's Guide Page 17