1Installation & User GuideMIRA CODAThese instructions are to be left with the userTHERMOSTATIC SHOWER VALVE
10Adjusting the TemperatureThe temperature is controlled by rotating the temperature selector knob.For safety reasons, the temperature is limited by a
11Read the section: Important Safety Information fi rst.Provided that the Mira Coda has been correctly installed and is operated in accordance with the
12Symptom Cause / Rectifi cation6. Drip from handset. A small amount of water may be retained in the fi tting after the shower control has been turned o
13MAINTENANCEGeneralThis Product is precision engineered and should give continued safe and controlled performance, provided:1. It is installed, com
14Maintaining the Non-Return ValvesThe non-return valves are located in the valve body, and are accessible through the inlet connectors.Caution! Ensur
151630.048Outlet ConnectorSPARES1630.045Temperature Knob Assembly1630.044Temperature Stop1630.043Thermostatic Cartridge1630.046Flow Cartridge1630.047F
161065367-W2-A © Kohler Mira Limited, August 2006CUSTOMER SERVICEUKAS
2PATENT APPLICATION GB 2 407 138A
3SPECIFICATIONSNotes1. The installation, commissioning and maintenance must be carried out in accordance with instructions supplied by the manufac
4INSTALLATIONGeneral1. The installation, commissioning and maintenance must be carried out according to instructions supplied, and must be conducted
5Solid Wall InstallationFor installation onto a stud partition or laminated panel wall, or onto unfi xed rear-entry pipework, refer to the next section
6 Caution! Ensure supply pipework is fl ushed before installing the shower valve.4. Assemble the shower valve with a sealing washer in each inlet and
74. Apply suitable thread sealant (not supplied) and attach the offset connectors to the pipework in the wall. Make sure that the connectors are lev
8 Caution! Ensure supply pipework is fl ushed before installing the shower valve.8. Assemble the shower valve with a sealing washer in each inlet and
95. Insert a small screwdriver into the notch and pry off the cover plate. 6. Unscrew the fi xing screw.7. Remove the temperature selector knob witho
Comments to this Manuals