Mira Escape User's Guide download pdf (Page 8)

Avoid layouts where the shower hose will be sharply kinked. This may reduce

the life of the hose.

A Soap Dish/Hose Retaining Ring is supplied to prevent the handset from

dropping below the spill-over level of the bath or shower tray, which could

lead to contamination from back-siphoning. The supplied Hose Retaining Ring

should meet the majority of user requirements for shower installations with

exible outlet ttings. However, there will be occasions when it will not provide

a suitable solution. In these instances an outlet double checkvalve, e.g. a

Mira DCV-H, must be tted. This will increase the required supply pressure

typically by 0.1 bar (see section “Accessories”).

Supply pipework MUST be ushed to clear debris before connecting to the

appliance.

To avoid damage to the case when soldered ttings are used, pre-solder the

pipework and ttings before connecting them to the inlet connector assembly.

Refrain from applying excessive force when making any connections. Always

provide mechanical support when making the plumbing connections.

The appliance is tted with a brass inlet compression assembly for connecting

to a 15mm supply pipe from the top, bottom or back. Double checkvalves, tted

in the inlet supply to the appliance, cause a pressure build-up, which could

exceed the maximum static inlet pressure and damage the appliance.

•

Isolating Valve

Avoid Sharp Kinks

Convenient height

for all the family

25 mm Min

Bath

Shower Tray

Fixed to nished

wall surface

Minimum

200mm from

ceiling

Hose Retaining Ring

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

Mira Escape User's Guide Page 8