Mira Orbis User's Guide download pdf (Page 10)

INSTALLATION

Warning! Isolate the electrical and water supplies before installing the shower. The

electricity must be turned off at the mains and the appropriate circuit fuse removed,

if applicable.

Note! An installation template is supplied to help you install the Mira Orbis.

Remove the service tunnel.

Cover

Cover Retaining

Screws

Service Tunnel

Remove the three cover retaining

screws.

Carefully remove the cover,

making sure that you do not

strain the multi-connector.

Carefully remove the multi-

connector from the socket on

the control PCB in the case

Determine the direction and route

of the incoming water supply:

falling (entering the shower from

the top), or rising (entering the

shower from the bottom).

Note! - DO NOT use an incoming

supply entering the shower

directly from the back. Add an

elbow to the supply pipe and

connect it as a rising or falling

supply.

Wall xings are not supplied. For solid wall structures a red rawl plug and a no. 8

x 1½” countersunk brass or stainless steel screw should be used. For other wall

structures such as panels alternative xings may be required. A minimum of 3 xing

screws should be used.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Mira Orbis User's Guide Page 10