Mira SHOWER FITTINGS User's Guide download pdf (Page 10)

10

USER MAINTENANCE

If you require a Mira trained service engineer or

agent, refer to section: ‘Customer Services’.

Fault Diagnosis

Symptom:

No flow or low flow rate from shower

•

ﬁ ttings.

Cause / Rectiﬁ cation:

Spray plate blocked, clean or renew.

•

Make sure that the hose is not blocked or •

twisted.

Head of water below minimum required (Min

•

supply pressure 0.5 Bar)

Problem with the shower control, refer to your

•

shower control installation and user guide.

—————————————

Symptom:

Drip from the showerhead.

•

Cause / Rectiﬁ cation:

A small amount of water may be retained in

•

the showerhead after the shower control has

been turned off. This is quite normal, changing

the angle of the showerhead may vary the

draining time.

Problem with the shower control, refer to your

•

shower control installation and user guide.

—————————————

Symptom:

Shower temperature changes when spray

•

action is adjusted.

Cause / Rectiﬁ cation:

Adjusting the spray action changes the ﬂ ow of

•

water. This may affect some shower controls

and plumbing installations. To minimise

the effect make sure that the spray plate is

clean.

Cleaning

Many household cleaners contain abrasives and

chemical substances, and should not be used for

cleaning plated or plastic ﬁ ttings.

These ﬁ nishes should be cleaned with a mild

washing up detergent or soap solution, and then

wiped dry using a soft cloth.

Use your thumb or a soft cloth to wipe any

limescale from the soft nozzles and the front

surface of the showerhead spray plate.

Important! The spray plate must be regularly

cleaned to make sure that the showerhead does

not become blocked.

Spray Plate Assembly - Internal

1. Remove the spray plate assembly.

2. Clean all the components with a stiff brush.

If necessary use a plastic kettle descalent

in accordance with the manufacturer's

instructions. Flush thoroughly with water

before the shower is used.

3. If necessary replace the 'O' seals. Refer to

section: Spare Parts.

4. Reﬁ t the components in reverse order. Make

sure that the 'O' seals and the inner and outer

nozzle retaining rings are ﬁ tted correctly.

Showerhead

Body

Outer Nozzle

Ring Retainer

Inner Nozzle

Ring Retainer

Spray Plate

Assembly

Adjuster Ring

'O' Seals

1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments